Jump to content

  • Quick Navigation
Photo
- - - - -

Mesh screen verification kit


  • You cannot start a new topic
  • Please log in to reply
1 reply to this topic

#1 tessalouwho

tessalouwho

    Grade - Active

  • IFSQN Active
  • 6 posts
  • 1 thanks
0
Neutral

  • United States
    United States

Posted 28 March 2018 - 03:48 PM

I am trying to find a kit to verify mesh sizes. A consultant I worked with once,  had a kit of "calibrated" needles that you could place in a small mesh screen to verify the size. A lot easier than using a calipers. (especially on a 80 mesh screen). Does anyone know where I could purchase? Did a internet search but couldn't find anything. Or any of the options.

 

Thanks in advance

 

 



#2 FurFarmandFork

FurFarmandFork

    Food Safety Consultant, Production Supervisor

  • IFSQN Fellow
  • 1,264 posts
  • 584 thanks
186
Excellent

  • United States
    United States
  • Gender:Male
  • Location:Oregon, USA

Posted 28 March 2018 - 05:59 PM

I've used a set of standardized tiny (for circuit boards) drill bits to verify small hole sizes. They aren't the best option, but it's a good way to have a "needle" of verified size. Of course if you spin them you'll put a hole in your mesh. But I use them to check hole sizes on bottles to see if the leak detection equipment upstream is catching the holes it should.


Austin Bouck
Owner/Consultant at Fur, Farm, and Fork.
Consulting for companies needing effective, lean food safety systems and solutions.

Subscribe to the blog at furfarmandfork.com for food safety research, insights, and analysis.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users