We just built a honey bottling room inside of our warehouse, and I would like some advice on the best recommended sealant for a corrugated sheet metal to sealed concrete junction.
As you may see from the attached photos, there are some gaps from the wall to floor. We will have a daily wash down on the floor and possibly smaller area wash downs in the room throughout the production day. The drain in the bottling room is on the opposite side of the room from an area outside of the room that can potentially standing water (small puddle) if left un-squeegeed. If this happens, it will take a great deal of work to clean the floor inside the room (going from across the room around the bottling line... introducing another drain is not an option at this time) if a good seal is not in place.
Thank you!