Need a solution for moisture analysis of cooked tuna loins?
Dear all,
Please help me to find out the solution for moisture analysis of cooked tuna loins.
We are using Ohaus MB 45 halogen type moisture anlyser. Please let me know the suitable time, temperature and weight for analysis?
Sounds like an interesting question. I have nothing to offer in terms of an answer to your question, sorry, but I'm choosing to post so I can review any answers that you might receive.
Dear all,
Please help me to find out the solution for moisture analysis of cooked tuna loins.
We are using Ohaus MB 45 halogen type moisture anlyser. Please let me know the suitable time, temperature and weight for analysis?
My first action would be to read the equipment manual.
If no help (or no manual), my second action would be to contact the equipment supplier.
You may be lucky and find someone here who uses the same system and can advise. i hope so. :smile:
Rgds / Charles.C
This is a different product than we test, and a different analyzer, but I think the concept is the same. We put about 5 to 10 g on the sample pan and set it so it will stop when the rate of moisture loss drops to 0.05%/min or below and it stops automatically. For our industry 105 degrees C is a standard analysis temperature, so we have adopted that. Also we set it to read the percent moisture lost on a wet basis (compared to the initial weight).
As to how to put the analyzer on those settings, Charles is right that that should be in the operation manual.
I hope this helps.
Matthew
Dear Matthew,
The information you provided is very helpful. Many thanks.
Can you please tell me which product you are testing?, Is it meat or not? Because moisture loss per minutes is very high for our product compared to 0.05%.
Kind Regards,
Jasim
Dear Jasim,
This appears to be the appropriate manual -
MB45 Moisture Analyzer.pdf 1.52MB 11 downloads
I have previously encountered the situation where uncertainties of results in rapid testers occurred. As detailed in the manual, numerous caveats may exist.
The typical "calibration" method is to compare rapid data with that from a "standard" procedure, eg fan-driven oven / 105degC or vacuum oven, using procedures such as AOAC.
From memory only, for canned tuna, vacuum was not necessary, ie no significant decomposition.
@Matthewcc - thanks for help / info.
Rgds / Charles.C
Dear Charles,
Thank you for your reply,
I am planning to run a calibration test with a standard oven method.
Regards / Jasim
Dear Matthew,
The information you provided is very helpful. Many thanks.
Can you please tell me which product you are testing?, Is it meat or not? Because moisture loss per minutes is very high for our product compared to 0.05%.
Kind Regards,
Jasim
We test plant material for moisture. It is usually dried, but sometimes it is fresh. Material being tested for moisture generally follows a decay curve and will eventually reach a moisture loss rate of 0.05% per minute. Of course there are exceptions, but I don't think meat would be one. It also helps to have material chopped finely and spread as flat as possible so that water can migrate out of the material more easily than if it is in one solid mass.
Matthew