What's New Unreplied Topics Membership About Us Contact Us Privacy Policy
[Ad]

Food process covers - what height should they be over the line?

Started by , Jan 08 2016 03:38 PM
6 Replies

Does anyone know of a specific height requirement for covers over processing lines / areas / conveyors etc...?

Share this Topic
Topics you might be interested in
ISO 22002 2025 Change Summary - Food Manufacturing Why do you have a food safety culture plan? Do non-food contact labels and film overwrap have to be covered when stored? Fragrance-Free Laundry Chemicals for Food Production Sites Producing Pet Treats in a Human Food Facility – Regulatory Requirements
[Ad]

As in height between the surface of the coveyor & the underside of cover? I do not believe I have ever seen that, here is what I have used for design (GMA sanitary design checklist)

 

G

 

All surfaces in non-product zones shall be readily accessible for cleaning and inspection. Installation for product contact areas and conveyor travel paths will maintain a minimum of 18 inches clearance from the floor.  Equipment design provides a 12 inch clearance from the floor to allow for cleaning and inspection. Equipment is located a minimum of 30 inches from overhead structures and 36 inches from the nearest stationary object. (Check applicable safety regulations)
1 Thank

What is the purpose of the covers?

What are they made of?

What is on the line?

 

Trying to picture it.

The purpose of the covers is to satisfy food safety concerns on conveyors, vibrating tables, sizing tables etc...

We have a number of them in place. They are constructed of Lexan / Plexiglass in metal frames. Our initial SQF L3 audit required we install one over an exposed production area.

We are bringing up a second production line that will need similar covering I am sure.

The purpose of the covers is to satisfy food safety concerns on conveyors, vibrating tables, sizing tables etc...

We have a number of them in place. They are constructed of Lexan / Plexiglass in metal frames. Our initial SQF L3 audit required we install one over an exposed production area.

We are bringing up a second production line that will need similar covering I am sure.

 

Thanks for the information.  I don't believe there is any guidance or requirement on distance, so it is up to you to design it based on practicalities. Obviously if the canopy is up in the stars then it would be questioned as to how effective it is also if it were touching food on the line then that would be a problem.  Whats your concern are your struggling to getting it close enough or too close?

 

Regards,

Simon

1 Thank

The concern was meeting any type of regulatory spec if one existed. We have decided on a distance that will allow access to the equipment for change overs and cleaning. This will be consistent with other covers currently in place.

Sounds good to me, but you're right it's always worth checking as rectifying after the fact would be costly.

 

Cheers,

Simon


Similar Discussion Topics
ISO 22002 2025 Change Summary - Food Manufacturing Why do you have a food safety culture plan? Do non-food contact labels and film overwrap have to be covered when stored? Fragrance-Free Laundry Chemicals for Food Production Sites Producing Pet Treats in a Human Food Facility – Regulatory Requirements Shortage of Skilled Technical Staff in the Food Industry Fellow Consultants – What’s Your Smartest Food Safety Hack? Ensuring Compliance with IFS Food Standards: Tips and Best Practices Food Safety Tips for Small Businesses: What to Prioritize? Food Safety Meetings