Environmental Yeast and Mould acceptable limits
Hi,
I am trying to set an acceptable limit for environmental swabs of yeast and mould. I have not been able to find any set guidelines on the limits. I understand that these limits are set internally and are based on previous test results. What are the common standards used? What would be a good starting point?
Hi Devashree
For Equipment TPC -for the food contact surfaces after a cleaning should be < 1,000 and be taking action above this level
For Hands - Coliform should be nil. Specially if hands are in contact with food and/or food contact surfaces
For Air - Yeast and Mould would be of slight concern if product is susceptible
Kind regards
Dr. Humaid Khan
Managing Director
Halal International Services
Sydney Australia
For Equipment TPC - You need to confirm if those are food contact surfaces and if they are after a clean (Normally I would be looking for < 1,000 and be taking action above this level) or to monitor during production? Also have you compared these results with product micro?
For Hands - any Coliform detected is not acceptable, especially if hands are in contact with food/food contact surfaces or capable of contaminating either or both.
For Air - Y&M would be of slight concern if product is susceptible and I would look to fog and repeat.
What are the general limits for Y&M on surfaces? eg. Walls, hard to reach parts of equipment, etc?
Hi,
I am trying to set an acceptable limit for environmental swabs of yeast and mould. I have not been able to find any set guidelines on the limits. I understand that these limits are set internally and are based on previous test results. What are the common standards used? What would be a good starting point?
For RTE food contact surfaces, directly after cleaning/sanitising, hopefully Nil, ie undetectable.
Environmental I am assuming you are referencing Zone 2, 3, and 4 areas only (non-product contact surfaces). You really have to do an internal study on this including before and after sampling of areas cleaned. What is physically possible to obtain and what resources it would take to get to that level. Also, the risk yeast and mold may have on the specific product(s) you produce because one product may be very susceptible while another product is hardly susceptible.
It is really tough to give a guideline or ballpark figure...
Any recommendations for maximum counts in the air sampling? Yeast or mold. .
We do < 10 cfu for yeast and < 10 cfu for mold at our facility.
Any recommendations for maximum counts in the air sampling? Yeast or mold. .
Zero context.
Difficult to meaningfully answer as noted Post 5.
JFI see refs here -