Hazard Analysis of Blow Moulding of Preforms
HI
We currently started to implement blow moulding on the preforms:
Can someone assist me with how to go about doing a hazard analysis
Kind Regards
What are the hazards associated with this process?
Hi
I am not too sure
THe preforms come in loaded into hoppers the fed in to the machine - heating in an oven and the blow moulded with air (Oil free compressor - the greases only used on the motor and no where else) . there is water from the cooling towers thar basically cool the moulds.i have identified the hazards of glass, dirt, wood, perspex, cleaning equipment, greases for the moulds etc but still struggling with doing a HACCP study
Not too sure what else is required.
Hi
I am not too sure
THe preforms come in loaded into hoppers the fed in to the machine - heating in an oven and the blow moulded with air (Oil free compressor - the greases only used on the motor and no where else) . there is water from the cooling towers thar basically cool the moulds.i have identified the hazards of glass, dirt, wood, perspex, cleaning equipment, greases for the moulds etc but still struggling with doing a HACCP study
Not too sure what else is required.
Your Hazard Analysis showed no food safety hazards, or maybe no hazard that needs a CCP. So just write it up as handled by the Preventive Controls you have in place, such as the oil-free air.
Ok but apart from what has been identifed : I am still stuck on how to do the hazard analysis