Metal Detector Settings
Our metal detectors are set at the following due to a specific customer; 2.0 mm fe, 1.2 mm Nfe and 1.85 mm SS. This was done about four years ago and fortress says this is very low for the units. Before we had 2.0 mm fe, 2.5 mm Nfe and 3.0 mm SS. What are your thoughts on going back to the original cards? What is the standard industry for metal detection size? Stacy
Our metal detectors are set at the following due to a specific customer; 2.0 mm fe, 1.2 mm Nfe and 1.85 mm SS. This was done about four years ago and fortress says this is very low for the units. before we had 2.0 mm fe, 2.5 mm Nfe and 3.0 mm SS. what are your thoughts on going back to the original cards?
What is the standard industry for metal detection size?
Stacy
Hi Stacy,
Implemented Sensitivity is related to (a) Validation capability and, perhaps, (b) Instrument Stability (eg frequency false positives/difficult food matrix).
Ideally Sensitivity is minimized using a "Standardised" Procedure for (a) but (b) may sometimes necessitate a degree of compromise.
I have never seen a test piece of 1.85mm ?
^^^(red) an FDA answer might be to use a setup such that no metal contamination is detectable in the output.
Afaik there is no specific "Standard". Different Industries may have varying "Best Practices".
Metal detection is a varied thing depending on your process
I agree with Charles, particularly about the test piece.......do you actually have a 1.85mm test wand?
Why do you want to move backwards in your detection? Seems to go against continuous improvement.......
For your reference/review
https://www.ams.usda...l Detection.pdf
https://www.grainsca...cp-final-en.pdf
Hi,
Sensitivity will depend on the product and pack size (i.e. detector orifice size), for example our system must deal with 25kg sacks and so the 3mm ferrous and 4mm stainless steel are the smallest that can be reliably detected. Perhaps consider producing a response curve using different size pieces, taking into consideration the background signal.
However, if you are not having problems with many false rejects or failure for the test pieces to sound then why change?
John
Hi,
Sensitivity will depend on the product and pack size (i.e. detector orifice size), for example our system must deal with 25kg sacks and so the 3mm ferrous and 4mm stainless steel are the smallest that can be reliably detected. Perhaps consider producing a response curve using different size pieces, taking into consideration the background signal.
However, if you are not having problems with many false rejects or failure for the test pieces to sound then why change?
John
Hi PQEE,
It may well be a "Best Practice" but IMHO, a necessary tolerance of up to 4mm suggests a POI. The problem is the 25kg of course.