Validation of pasteurization process
Started by mrtipex, Oct 08 2024 05:42 AM
In the case of accumulated lethality in a pasteurization process consisting of heating (plate heat exchanger), holding tube, regeneration, and cooling stages: Should the accumulated lethality be calculated considering only the holding tube, or should the other stages be included as well?
thanks in advance
Shelf-life validation gap: HACCP says 24 months frozen, but testing only ran 4 months (beef plant)
Metal Detector Validation, Verification, Calibration & Challenge
Magnet Validation
Validation study consumer cooking instructions for 5-log Listeria reduction (par-baked pizza)
Hot fill validation meat stews and sauces
[Ad]
Hi mrtipex,
:welcome:
Welcome to the IFSQN forums
Normally the calculation is based on the temperature*/time in the holding tube.
* Temperature is measured at the end of the holding tube.
Kind regards,
Tony
1 Thank
Shelf-life validation gap: HACCP says 24 months frozen, but testing only ran 4 months (beef plant)
Metal Detector Validation, Verification, Calibration & Challenge
Magnet Validation
Validation study consumer cooking instructions for 5-log Listeria reduction (par-baked pizza)
Hot fill validation meat stews and sauces
Shelf Life Validation for Dietary Supplements (Probiotics, Vitamin C, Enzymes)
Process validation of CCP's - What should the frequency be?
Shelf life validation for ambient stable sauces
Is Scientific Literature Enough for ISO 22000 Validation, or Is Practical Testing Required?
Supervising vs Unsupervised Allergen Cleaning Validation