What's New Unreplied Topics Membership About Us Contact Us Privacy Policy
[Ad]

Stainless Steel Rodent Catch-alls

Started by , Jan 06 2025 03:50 PM
5 Replies

Has anyone found or tried a stainless steel rodent catch-all?

 

I have a few areas where some processing aids are corroding even galvanized catch-alls.

 

Plastic would be an option if there are no stainless products available.

 

 

Share this Topic
Topics you might be interested in
Is 316 stainless steel necessary as opposed to 304 stainless steel for food-contact surfaces on equipment? Stainless Steel Chain Mail Scour Pads Portable Stainless Steel Mirror on Handles for Sanitation Inspections Temperature Taking of 200 gal Stainless Steel Tanks Stainless Steel Chopping board, are they viable options?
[Ad]

I would expect aluminum to be less expensive and sufficiently resistant in most cases.

 

We just use the "cheap" galvanized ones.  The units in the chemical storage room just get replaced more often ~ and the ones that people manage to smash with lifts/jacks (one more reason not to splurge on stainless).

1 Thank

Never seen one---------quick google search didn't show any either

 

for the cost of galvanized, just replace them                    do you have an exterior door on your chem room?  If not, you can probably justify removing that trap---particularly if you've NEVER had a mouse in that trap location

1 Thank

I've never seen a stainless tin cat either.  Do as others have stated, risk assess the area and the need for the trap location, and just use the cheap galvanized and replace as needed.  

1 Thank

Plastic, yes. I ran a FS program in a salt manufacturer (ammonium chloride and ammonium sulfate) and it was hell on regular tin cats. I ended up keeping my own stock of both tin and plastic and the PCO would replace as needed. I'd keep the plastic in high dust areas and tin in warehousing.

Sometimes I felt like it was more trouble than it was worth; I still needed to replace the plastics on a somewhat regular basis, and they were quite a bit more expensive than the cheap tin cats.

1 Thank
Hi, we are seafood processing company and situated right in front of sea, means high humidity so we can not think of anything else but stainless steel, yes you are right that there are no stainless steel traps available in the market, but we made them in-house, fortunately we have a good fabricator in our staff, so we have provide him with the sample traps and he made the same for us in stainless steel. In glue traps we have used the sliding acrylic sheets on top to view if anything trapped in it and it also helps to change the glue sheets conveniently, our bait trapes are of general design, even we have made stainless steel ILTs. all worked well and are in same condition after one year of use. 
 
I have also experience of working in salt. in salt plant stainless steel get rust and need frequent cleaning and buffing, so in salt, plastic is the best option.

Similar Discussion Topics
Is 316 stainless steel necessary as opposed to 304 stainless steel for food-contact surfaces on equipment? Stainless Steel Chain Mail Scour Pads Portable Stainless Steel Mirror on Handles for Sanitation Inspections Temperature Taking of 200 gal Stainless Steel Tanks Stainless Steel Chopping board, are they viable options? EU and FDA standard limits for ferrous, non ferrous and stainless steel Measurements of effectiveness of stainless separators/dividers How to fill and seal hollow tube stainless steel equipment legs? Looking for a an effective cleaning method for High Carbon Stainless Steel? Grades of stainless - Is this being super picky?