Separate Autoclave for Sterilization and decontamination
Started by sac, Jan 03 2013 04:15 PM
Is there any problem can happen if we use 1 autoclave for both sterlization of media,utensils etc and decontamination of used media,culture plates etc....Is this a violation of GLP?some auditors strongly suggest for two separate autoclaves for this purpose?what is International standards are describing this matter???
USA FDA Requirements for Food Canning Establishments - Separate SID for Each Fat Version or Single ID for All 400ml Coconut Milk Products?
Fresh Sushi - Separate HACCP Plan for vegetables used?
Adding Separate Warehouse for Finished Goods
Do I need a Separate HACCP Study for an Off-Site Warehouse
Integrating BRC requirements into an existing system without creating a separate BRC Manual
[Ad]
As per GLP should have two Autoclaves why because there is chancess of cross contamination and will get fault micro results ..
one for Media preparion and other one will be using for destory and discard the culture media (Inculated and contaminated) ..
Regards,
one for Media preparion and other one will be using for destory and discard the culture media (Inculated and contaminated) ..
Regards,
1 Thank
Isn't the use of 2 autoclaves to prevent cross-contamination counter-intuitive? If you have micro cross-contamination using a single autoclave, then your autoclave is not operating properly in the first place...
1 Thank
USA FDA Requirements for Food Canning Establishments - Separate SID for Each Fat Version or Single ID for All 400ml Coconut Milk Products?
Fresh Sushi - Separate HACCP Plan for vegetables used?
Adding Separate Warehouse for Finished Goods
Do I need a Separate HACCP Study for an Off-Site Warehouse
Integrating BRC requirements into an existing system without creating a separate BRC Manual
Separate internal audit checklist by area for FSSC 22000 V.5.1
Do we need a separate raw material risk assessment as well as TACCP and VACCP?
Lab included in our audit but is a separate entity
Do you need separate sinks for washing hands and equipment?
Control measures when no room for a separate maintenance workshop